parameters
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| parameters [2015/05/17 16:29] – dmitry | parameters [2015/05/17 16:31] – dmitry | ||
|---|---|---|---|
| Line 15: | Line 15: | ||
| === Required parameters === | === Required parameters === | ||
| - | Any parameters (except calculated parameters) can be marked as **required** using respective checkbox in parameter editor. All required parameters are prompted on full project runs -- i.e. when running a project with all transformations not calculated (e.g. right after opening a project) or when performing Reload and Run. | + | Any parameter |
| === Command line execution === | === Command line execution === | ||
| Parameter values can be defined from command line. If a project has required parameters they must be defined if running in command line mode. Defining non-required parameters are optional, if such parameter wasn't defined it's default value will be used instead. Calculated parameters can't be defined from command line. New parameters can't be created from command line. See [[command_line|command line syntax]] for more details. | Parameter values can be defined from command line. If a project has required parameters they must be defined if running in command line mode. Defining non-required parameters are optional, if such parameter wasn't defined it's default value will be used instead. Calculated parameters can't be defined from command line. New parameters can't be created from command line. See [[command_line|command line syntax]] for more details. | ||
parameters.txt · Last modified: 2021/01/14 19:50 by dmitry